| Frequency Characteristics (Standard Waveforms) |
| Sine | 0.01 Hz to 20 MHz |
| Square | 0.01 Hz to 20 MHz |
| Triangle, Ramp | 0.01 Hz to 2 MHz |
| Accuracy | 0.005% (50 ppm) |
| Resolution | 6 digits or 10 mHz |
| Arbitrary Characteristics |
| Waveform length | 2 points to 1,000 points |
| Vertical resolution | 12 bits |
| Sampling rate | 20ns to 50s |
| Accuracy | 0.005% (50 ppm) |
| Resolution | 4 digits |
| Output Characteristics |
| Amplitude Range | 10mV to 10Vp-p into 50Ω |
| Resolution | 3 digits (1000 counts) |
| Amplitude Accuracy | ±2% ± 20mV of the programmed output from 1.01V - 10V |
| Flatness | 0.5 dB at 1 MHz
1 dB to 20 MHz |
| Offset Range | ± 4.5V into 50Ω, depending on the Amplitude setting |
| Offset Resolution | 10 mV with 3 digits resolution |
| Offset Accuracy | ±2% ± 10mV into 50Ω |
| Output Impedance | 50Ω |
| Output Protection | The instrument output is protected against short circuit or accidental voltage practically available in electronic laboratories, applied to the main output connector. |
| Filter | 9 pole Elliptic |
| Waveform Characteristics |
Harmonic Distortion | DC - 20 kHz | -55 dBc | | 20 kHz - 100 kHz | -50 dBc | | 100 kHz - 1 MHz | -40 dBc | | 1 MHz - 20 MHz | -30 dBc |
|
| Spurious |
| Square Rise/Fall Time | < 18 ns (10% to 90%) at full amplitude into 50Ω |
| Variable Duty Cycle | 20% to 80% to 2 MHz for Square and 10% - 90% for Triangle |
| Symmetry at 50% | < 1% |
| Operating Modes |
| Continuous | Output continuous at programmed parameters. |
| Triggered | Output quiescent until triggered by an internal or external trigger, then one waveform cycle is generated to programmed parameters. Up to 10 MHz trig rate for ARB waveforms and 1 MHz in DDS mode. |
| Gate | Same as triggered mode, except waveform is executed for the duration of the gate signal. The last cycle started is completed. |
| Burst | 2 - 65,535 cycles |
| Trigger Source | Trigger source may be internal, external or manual. Internal trigger rate 0.1 Hz - 1 MHz (1 µs - 10 s) |
| Modulation Characteristics |
Amplitude Modulation | Internal | 0.1 Hz - 20 kHz sine, square or triangle waveform. Variable modulation from 0% to 100%. | | External | 5Vp-p for 100% modulation, 10 kΩ input impedance. |
|
Frequency Modulation | Internal | 0.1 Hz - 20 kHz sine wave, square or triangle. | | External | 5Vp-p for 100% deviation, 10 kΩ input impedance. |
|
| Sweep Characteristics |
| Sweep Shape | Linear and Logarithmic, up or down |
| Sweep Time | 10 ms to 100 s. |
| Sweep trigger | internal, external, continuous or burst |
| Inputs and Outputs |
| Trigger In | TTL compatible.
Max. rate 10 MHz.
Minimum width 50ns. |
| Sync Out | TTL pulse at programmed frequency, 50Ω source impedance. |
| Modulation IN | 5 Vp-p for 100% modulation.
10 kΩ input impedance.
DC to > 20 kHz minimum bandwidth. |
| General |
| Store memory | 20 full panel settings at power-off |
| Arbitrary memory | 1,000 points in flash memory |
| Dimensions | 8.4'' (213 mm) wide
3.5'' (88 mm) high
8.3'' (210 mm) deep |
| Weight | Approx. 2.5 kg |
| Power | 90V - 264V
30 VA max |
Temperature | Operating | 0°C to +50°C | | Non-operating | -10°C to +70°C |
|
| Humidity | 95% RH, 0°C to 30°C |
| EMC | According to EN55011 for radiated and conducted emissions. |
| Electrical Discharge Immunity | According to EN55082 |
| Safety Specifications | According to EN61010 |
| CE Labeled |
| Specifications are subject to change without notice. For the most current product information please visit http://www.bkprecision.com/. |
Specifications
