The model 206 cable tester is a stand alone test device. It is designed to test popular PC data cables, printer, monitor, modem, mouse extension, game, BNC coax, RJ45, 1394, and USB cables by identifying the wire connection status: open, short, cross, miswire, and continuity of wires and pin configuration. It is a very good tool for most cable dealers, cable assembly house or system integrator to quickly check the pin configuration or troubleshooting in every work environment.

•Tests most PC data cables and network cables, such as printer, monitor, modem, mouse extension, BNC coax, RJ45, 1394, and USB cables
•Detects open, short, miswire, continuity, game, and pin configuration
•Ideal for: cable dealers, cable assembly house or system integrators
•Quick and easy to use
•LED display for easy identification
•DC battery compartment
•Auto and manual modes
•Reverse test
Datasheet (PDF file)Manual (PDF file)Specifications

The 230A tests thin Ethernet (BNC), 10BaseT (UTP/STP), 100BaseTx, RJ45, TIA 568A, TIA 568B, and Token Ring cables within a few seconds. It detects miswiring, polarization, and continuity. The 230A also tests the ground of shielded twisted pair cables. With the remote unit, you can remotely test installed cable either from the wall plate or patch panel.

•Auto scans thin Ethernet (BNC), 10BaseT (UTP/STP), 100BaseTx, RJ45, 356A, TIA 568A, TIA 568B, and Token Ring cables in seconds
•Detects miswiring, polarization, and continuity
•Also tests the ground of shielded twisted pair cables
•Tests cables before or after installation with the remote unit
•LED display for clear indication of problems

The 231A can easily read the correct pin configuration of 10BaseT cable (category 5), 100BaseTx, 10Base2 cable (coax) and RJ45/RJ11 modular cables, 356A, TIA 568A, TIA 568B and Token Ring cables by comparing one transmitting end to the corresponding receiving end. With the remote kit, it can test cables installed far away either on wall plate or patch panel up to 1000ft away. It is easy to verify the cable continuity, open, short, and cross connect, featuring auto or manual scan for pin-out indicators.

• Tests 10BaseT, 100BaseTx, 10Base2, RJ45, RJ11, 356A, TIA 568A, TIA 568B, and Token Ring cables
• Detects open, short, cross, and continuity
• Tests Point to Point, rather than Pair to Pair
• Quick and easy to use
• Tests cables on wall plate or patch panel up to 1000 ft away with the remote kit
• Easy to read LED display

Continuity Tester for twisted pair cables and F Type coaxial cables

Features:

• Tests for shorts, opens, miswires and reversals
• Tests EIA/TIA568A and 568B and 10Base-T
• Shield detection tests shield integrity
• Tests installed wiring and jumper cables
• "F" connector for troubleshooting CAT5 coaxial installations
• Tests for CAT5 opens and shorts
• Tests CAT5 cable lengths from 3 to 600ft (0.9 to 183m)

Transmitter/Receiver enables one person to remotely identify up to 16 wires

Features:

• Troubleshoot electrical/electronic circuits and identify up to 16 local or installed lines
• MultiMeter functions include: AC/DC Voltage and Current, Resistance, Diode, and Continuity
• Transmitter/Receiver enables one person to remotely identify up to 16 wires
• Wire voltage check from 5 to 16VDC
• Data Hold and Max Hold, Auto power off
• Low battery indicator (transmitter and receiver)
• Complete with 16-line Transmitter, MultiMeter/Receiver, two 9V batteries, pouch case, and 2 AAA batteries